Which of the following circuit parameters would be most likely to limi – McqOptions

MCQOPTIONS

1.	Which of the following circuit parameters would be most likely to limit the maximum operating frequency of a flip-flop?
A.	setup and hold time
B.	clock pulse HIGH and LOW time
C.	propagation delay time
D.	clock transition time
Answer» D. clock transition time

Discussion

No Comment Found

Related MCQs

The term describes the time that an active signal must be present at the input to a flip-flop before an active clock edge is applied.
A Schmitt trigger has a positive feedback circuit and experiences a phenomenon called .
A series circuit can be used to generate a power-up (automatic) reset signal.
The output of a standard TTL NAND gate is used to pull an LED indicator LOW. The LED is in series with a 470- resistor. What is the current in the circuit when the LED is on?
Can the automatic circuit be used to set a flip-flop rather than reset the flip-flop?
Which of the following flip-flop timing parameters indicates the time it takes a output to respond to a input?
How much setup time () is required for the 74LS76?
Decoupling capacitors should be tied from on one device to ground on a different device.
A 0.01-F capacitor is recommended by TTL manufacturers for ________ the power supply.
A Schmitt trigger has + = 2.0 V and – = 1.2 V. What is the hysteresis voltage of the Schmitt trigger?