When any interrupt is enabled, then where does the pointer moves immed – McqOptions

MCQOPTIONS

1.	When any interrupt is enabled, then where does the pointer moves immediately after this interrupt has occurred?
A.	to the next instruction which is to be executed
B.	to the first instruction of ISR
C.	to the first location of the memory called the interrupt vector table
D.	to the end of the program
Answer» D. to the end of the program

Discussion

No Comment Found

Related MCQs

This program code will be executed continuously:
This program code will be executed once:
The contents of the accumulator after this operation MOV A,#0BH ANL A,#2CH will be
When the 8051 is reset and the line is LOW, the program counter points to the first program instruction in the:
This program code will read data from port 0 and write it to port 2, and it will stop looping when bit 3 of port 2 is set:
The following program will receive data from port 1, determine whether bit 2 is high, and then send the number FFH to port 3: READ: MOV A,P1 ANL A,#2H CJNE A,#02H,READ MOV P3,#FFH
When the 8051 is reset and the line is HIGH, the program counter points to the first program instruction in the:
The following command will copy the accumulator to the location whose address is 23H: MOV 23H,A
The contents of the accumulator after this operation MOV A,#2BH ORL A,00H will be:
The following program will cause the 8051 to be stuck in a loop: