When a flip-flop is used in a circuit, we only have to consider the l – McqOptions

MCQOPTIONS

1.	When a flip-flop is used in a circuit, we only have to consider the level at and at the active clock edge to know the states of the outputs.
A.	True
B.	False
Answer» C.

Discussion

No Comment Found

Related MCQs

A MOD-16 ripple counter is holding the count 1001. What will the count be after 31 clock pulses?
After 10 clock cycles, and assuming that the DATA input had returned to 0 following the storage sequence, what values would be stored in 4, 3, 2, 1, 0 of the register in Figure 7-5?
A 5-bit asynchronous binary counter is made up of five flip-flops, each with a 12 ns propagation delay. The total propagation delay (t) is ________.
Any divide-by- counter can be formed by using external gating to ________ at a predetermined number.
The designation means that the ________.
What is the maximum delay that can occur if four flip-flops are connected as a ripple counter and each flip-flop has propagation delays of = 22 ns and = 15 ns?
The term refers to events that do not occur at the same time.
The term , as applied to counter operations, means that the counter is clocked such that each flip-flop in the counter is triggered at the same time.
A J-K flip-flop excitation table lists the present state, the next state, and the and levels required to produce each transition.
A parallel in/serial out shift register enters all data bits simultaneously and transfers them out one bit at a time.