The primary use for Gray code is: – McqOptions

MCQOPTIONS

1.	The primary use for Gray code is:
A.	coded representation of a shaft's mechanical position
B.	turning on/off software switches
C.	to represent the correct ASCII code to indicate the angular position of a shaft on rotating machinery
D.	to convert the angular position of a shaft on rotating machinery into hexadecimal code
Answer» B. turning on/off software switches

Discussion

No Comment Found

Related MCQs

Use the weighting factors to convert the following BCD numbers to binary. 0101 0011 0010 0110 1000
For the following conditions on a 7485 magnitude comparator, what will be the state of each of the three outputs? A0 = 0B0 = 1IA < B = 0 A1 = 1B1 = 0IA = B = 1 A2 = 1B2 = 0IA > B = 0 A3 = 0B3 = 0
Exclusive-AND gates are needed for conversions between Gray code and binary code.
The basic comparator evaluates two binary strings bit by bit and always outputs a 1.
In a priority encoder, the input with the highest priority is represented on the output.
The 74154 is a 1-of-16 decoder. It accepts a 4-bit binary input.
Before you can make a design you must decide if you want an active-HIGH output.
A basic multiplexer principle can be demonstrated through the use of a:
A truth table with output columns numbered 0‚Äì15 may be for which type of decoder IC?
What is the status of the inputs S0, S1, and S2 of the 74151 eight-line multiplexer in order for the output Y to be a copy of input I5?