The negative logic is symbolized with – McqOptions

MCQOPTIONS

1.	The negative logic is symbolized with
A.	1
B.	0
C.	up
D.	down
Answer» C. up

Discussion

No Comment Found

Related MCQs

The term describes the time that an active signal must be present at the input to a flip-flop before an active clock edge is applied.
A Schmitt trigger has a positive feedback circuit and experiences a phenomenon called .
A series circuit can be used to generate a power-up (automatic) reset signal.
The output of a standard TTL NAND gate is used to pull an LED indicator LOW. The LED is in series with a 470- resistor. What is the current in the circuit when the LED is on?
Can the automatic circuit be used to set a flip-flop rather than reset the flip-flop?
Which of the following flip-flop timing parameters indicates the time it takes a output to respond to a input?
How much setup time () is required for the 74LS76?
Decoupling capacitors should be tied from on one device to ground on a different device.
A 0.01-F capacitor is recommended by TTL manufacturers for ________ the power supply.
A Schmitt trigger has + = 2.0 V and – = 1.2 V. What is the hysteresis voltage of the Schmitt trigger?