An analog voltmeter uses external multiplier settings. With a multipli – McqOptions

MCQOPTIONS

1.	An analog voltmeter uses external multiplier settings. With a multiplier setting of 20kΩ, it reads 440V and-with a multiplier setting of 80kΩ it reads 352V. For a multiplier setting of 40kΩ,voltmeter reads [GATE2012]
A.	371V
B.	383V
C.	394V
D.	406V
Answer» E.

Discussion

No Comment Found

Related MCQs

The rate at which charge carriers flow is measured in
An analog voltmeter uses external multiplier settings. With a multiplier setting of 20kΩ, it reads 440V and-with a multiplier setting of 80kΩ it reads 352V. For a multiplier setting of 40kΩ,voltmeter reads [GATE2012]
An average-reading digital multimeter reads 10V when fed with a triangular wave, symmetric about the time-axis.For the same input an rms-reading meter will read [GATE]
A voltmeter should have
A watt-hour meter measures
The device used to indicate the presence of an electric current is
A hot-wire ammeter
The pressure coil of a dynamo meter type wattmeter is [GATE2009]
The two inputs of a CRO are fed with two stationary periodic signals. In the X-Y mode, the screen shows a figure which changes from ellipse to circle and back to ellipse with its major axis changing orientation slowly and repeatedly. The following inference can be made from this. [GATE2009]
A piezoelectric crystal has a thickness of 2.5mm and a voltage sensitivity of 0.05Vm/N. The piezoelectric crystal is subjected to an external pressure of 1.6 x 106N/m2,then the corresponding output voltage is, [IES2010]