________ ADCs use no clock signal, because there is no timing or seque – McqOptions

MCQOPTIONS

1.	________ ADCs use no clock signal, because there is no timing or sequencing required.
A.	Actuator
B.	Dual
C.	Flash
D.	Bipolar
Answer» D. Bipolar

Discussion

No Comment Found

Related MCQs

If the least significant bit (LSB) of a four-bit binary-weighted resistor D/A converter connects to a 200 resistor, then the resistor needed for the next bit is 100 .
The current across the MSB "rung" of a 4-bit /2 ladder DAC if the reference voltage is 5 v and R is 8 is 625 A.
An AD7524 is an eight-bit D/A converter that uses an /2 ladder network.
A 4-bit /2 D/A converter has a reference of 5 V. What is the analog output for the input code 0101?
What is the major advantage of the /2 ladder D/A converter as compared to a binary-weighted D/A converter?
What is the major advantage of the /2 ladder DAC as compared to a binary-weighted-input DAC?
The primary disadvantage of the flash A/D converter is the large number of comparators required.
Flash A/D converters depend on an input clock pulse to perform each conversion.
In a digital storage scope, when memory is full, the next data point is lost.
The current across the MSB "rung" of a 4-bit R/2R ladder DAC if the reference voltage is 5 v and R is 8 is 625 A.