A cathode ray oscilloscope typically has an input impedance of. – McqOptions

MCQOPTIONS

1.	A cathode ray oscilloscope typically has an input impedance of.
A.	1 GΩ
B.	1 kΩ
C.	1 MΩ
D.	1 Ω
Answer» D. 1 Ω

Discussion

No Comment Found

Related MCQs

High frequency (in the MHz range) and low amplitude (in the mV range) signals are best measured using
A CRT has an anode voltage of 2000 V and parallel deflecting plates 2 cm long and 5 mm apart. The screen is 30 cm from the centre of the plates. If the input voltage is applied to the deflecting plates through amplifiers having an overall gain of 100, the input voltage required to deflect the beam through 3 cm will be
A dual-beam CRO
CROs are used to measure frequencies up to ________.
A CRO can display:
In a Cathode Ray Tube, the focusing anode is located
A cathode ray oscilloscope typically has an input impedance of.
Oscilloscopes are normally designed such that the product of bandwidth and rise time is:
An oscilloscope displays a 50 Hz, 20 V peak-to-peak sine waveform. Identify the reading in a digital multimeter for the same signal.
Loading by the measuring instruments introduces an error in the measured parameter. Which of the following devices gives the most accurate result?