Explore topic-wise MCQs in Testing Subject.

This section includes 657 Mcqs, each offering curated multiple-choice questions to sharpen your Testing Subject knowledge and support exam preparation. Choose a topic below to get started.

1.

__In amplitude modulation, bandwidth is ___________ the audio signal frequency__

A. Thrice
B. Four times
C. Twice
D. None of the above
Answer» D. None of the above
2.

__In an AM wave, the majority of the power is in _____________

A. Lower sideband
B. Upper sideband
C. Carrier
D. None of the above
Answer» D. None of the above
3.

__The function of ferrite antenna is to _____________

A. Reduce stray capacitance
B. Stabilise d.c. bias
C. Increase the Q of tuned circuit
D. Reduce noise
Answer» D. Reduce noise
4.

__In an AM wave useful power is carrier by _____________

A. Carrier
B. Sidebands
C. Both sidebands and carrier
D. None of the above
Answer» C. Both sidebands and carrier
5.

__The letters AVC stand for _____________

A. Audio voltage control
B. Abrupt voltage control
C. Automatic volume control
D. Automatic voltage control
Answer» D. Automatic voltage control
6.

_Demodulation is done in ___________$?

A. Receiving antenna
B. Transmitter
C. Radio receiver
D. Transmitting antenna
Answer» D. Transmitting antenna
7.

In a transmitter ___________ oscillator is used$?

A. Hartley
B. RC phase-shift
C. Wien-bridge
D. Crystal
Answer» E.
8.

In TV transmission, picture signal is ___________ modulated$?

A. Frequency
B. Phase
C. Amplitude
D. None of the above
Answer» D. None of the above
9.

If a radio receiver amplifies all the signal frequencies equally well, it is said to have high ___________$?

A. Sensitivity
B. Selectivity
C. Distortion
D. Fidelity
Answer» E.
10.

The major advantage of FM over AM is ___________$?

A. Reception is less noisy
B. Higher carrier frequency
C. Smaller bandwidth
D. Small frequency deviation
Answer» B. Higher carrier frequency
11.

The diode detector in an AM radio receiver is usually found ___________$?

A. Before the first RF stage
B. After the first RF stage
C. After several stages of amplification
D. None of the above
Answer» D. None of the above
12.

When the modulating signal controls the frequency of the carrier, we get___________$?

A. Phase modulation
B. Amplitude modulation
C. Frequency modulation
D. May be any one of the above
Answer» D. May be any one of the above
13.

Overmodulation results in ___________$?

A. Weakening of the signal
B. Excessive carrier power
C. Distortion
D. None of the above
Answer» D. None of the above
14.

Modulation is done in ___________?

A. Transmitter
B. Radio receiver
C. Between transmitter and radio receiver
D. None of the above
Answer» B. Radio receiver
15.

At 100% modulation, the power in each sideband is ___________ of that of carrier

A. 50%
B. 40%
C. 60%
D. 25%
Answer» E.
16.

Man made noise are ___________ variations.

A. Amplitude
B. Frequency
C. Phase
D. Both phase and frequency
Answer» B. Frequency
17.

A high Q tuned circuit will permit an amplifier to have high ___________

A. Fidelity
B. Frequency range
C. Sensitivity
D. Selectivity
Answer» E.
18.

A 50 kW carrier is to be amplitude modulated to a level of 85%. What is the carrier power after modulation?

A. 50 kW
B. 5 kW
C. 8 kW
D. 25 kW
Answer» B. 5 kW
19.

In a radio receiver, noise is generally developed at ___________

A. IF stage
B. Receiving antenna
C. Audio stage
D. RF stage
Answer» E.
20.

In India, ___________ modulation is used for radio transmission

A. Frequency
B. Amplitude
C. Phase
D. None of the above
Answer» C. Phase
21.

In superhetrodyne receiver, the input at mixer stage is ___________

A. IF and RF
B. RF and AF
C. IF and AF
D. RF and local oscillator signal
Answer» E.
22.

In a superhetrodyne receiver, the difference frequency is chosen as the IF rather than the sum frequency because ___________

A. The difference frequency is closer to oscillator frequency
B. Lower frequencies are easier to amplify
C. Only the difference frequency can be modulated
D. None of the above
Answer» C. Only the difference frequency can be modulated