MCQOPTIONS
Home
About Us
Contact Us
Bookmark
Saved Bookmarks
Testing Subject
General Aptitude
Logical and Verbal Reasoning
English Skills Ability
Technical Programming
Current Affairs
General Knowledge
Finance & Accounting
GATE (Mechanical Engineering)
Chemical Engineering
→
Electrical Engineering
→
Gate (EE) 2018
→
In D.C. machines the width of the duct is usually
1.
In D.C. machines the width of the duct is usually
A.
mm
B.
mm
C.
mm
D.
0 mm
Answer» E.
Show Answer
Discussion
No Comment Found
Post Comment
Related MCQs
The operation of a D.C. machine with large air gap lengths is comparatively
In a D.C. machine the number of brush arms is _____ the number of poles.
The change in flux linkages can be caused in which of the following ways ?
Yokes with rectangular cross-section are used for
________ is the common method of applying brushes to the commntator.
Commonly used standard capacitor is
Aluminium when adopted as a conductor material in ______ transformers, decreases the overall cost of the transformer
The mcrease in heat dissipation by air blasts is due to increase in
are always double layer type.
The power of a n-phase circuit can be measured by using a minimum of
Reply to Comment
×
Name
*
Email
*
Comment
*
Submit Reply
Your experience on this site will be improved by allowing cookies. Read
Cookie Policy
Reject
Allow cookies
