In CMOS manufacturing process Sheet resistance is used instead of resi – McqOptions

MCQOPTIONS

1.	In CMOS manufacturing process Sheet resistance is used instead of resistivity because:
A.	Resistivity is same for all doped regions
B.	Resistivity and thickness are characteristics which cannot be controlled by the circuit designer, and it is expressed as the single sheet resistance parameter
C.	Sheet resistance is dimensionless quantity
D.	Sheet resistance is equal to resistivity
Answer» C. Sheet resistance is dimensionless quantity

Discussion

No Comment Found

Related MCQs

If standard area is 2λ x 2λ, then the standard capacitance of a gate of length 30λ and width 6λ is?
For λ based design, what is the standard unit of capacitance, (λ=5µm)?
The typical values of sheet resistance for polysilicon semiconductor is?
The typical values of sheet resistance for the n-well semiconductor is ____________
The resistance of the semiconductor material is 800Ω. The sheet resistance if the dimensions of the material is 0.125µm wide and 1 mm long is?
Sheet resistance of semiconductor is directly measured using ___________
Sheet resistance of a semiconductor is ___________
For semiconductors doped through diffusion or through surface peaked ion implantation we derive the sheet resistance as ___________
Compute the sheet resistance of a 0.17 µm thick Cu wire if resistivity of Cu wire is 1.7 µΩ-cm.
In CMOS manufacturing process Sheet resistance is used instead of resistivity because _______________