A vibration galvanometer is – McqOptions

MCQOPTIONS

1.	A vibration galvanometer is
A.	Low - pass characteristic.
B.	High - pass characteristic
C.	Band - pass characteristic with very narrow passband.
D.	Band - stop characteristic with very narrow stopband.
Answer» D. Band - stop characteristic with very narrow stopband.

Discussion

No Comment Found

Related MCQs

A bridge circuit works at a frequency of 2 kHz. Which of the following can be used as detectors for detection of null conditions in the bridge?
In figure, Za = 100 ∠50°, Zb = 300 ∠-90° and Zc = 200 ∠0°. For balanced condition, Zd will be -
In De-Sauty bridge (unmodified form) balance is obtained when
Owen bridge is used to
A potentiometer R5 is put in the apex of the bridge shown in the figure to balance the circuit. If Ru = 500 Ω; Rv = 500 Ω; R2 = 515 Ω; R3 = 480 Ω; and R5 = 100 Ω, then find the values of R6 and R7 to balance the bridge and compensate for the unequal values of R2 and R3.
Match List-I(Bridge) with List-II (Parameter to be measured) and select the correct answer:List-IList-IIAMaxwell’s bridge1FrequencyBHay’s bridge2Inductance medium Q-coils (1 < Q < 10)CSchering bridge3Inductance of high coils (Q > 10)DWein bridge4Capacitance
Assertion (A): De-Sauty’s bridge is suitable only for pure capacitorReason (R): Capacitors are mostly perfect
Insulation resistance of a cable can be measured by which of the following?i. Meggarii. Galvanometer method
A 1-mA meter movement with an internal resistance of 100 Ω is to be converted into a 0-100 mA ammeter. The value of shunt resistance will be
For measurement of mutual inductance, we can use