Explore topic-wise MCQs in Civil Engineering.

This section includes 185 Mcqs, each offering curated multiple-choice questions to sharpen your Civil Engineering knowledge and support exam preparation. Choose a topic below to get started.

1.

and are the weights of a cylinder containing partially compacted and fully compacted concrete. If the compaction factor is 0.95, the workability of concrete is

A. extremely low
B. very low
C. low
D. high
E. none of these.
Answer» E. none of these.
2.

If the average compressive strength is 4000 kg/cm and standard deviation is 500, the co-efficient of variation is

A. 10%
B. 12.5%
C. 15%
D. 18.5 %
E. 20%
Answer» C. 15%
3.

Di-calcium silicate (CS)

A. hydrates rapidly
B. generates less heat of hydration
C. hardens rapidly
D. provides less ultimate strength to cement
E. has less resistance to sulphate attack.
Answer» C. hardens rapidly
4.

Density of light weight aggregate concrete is about .. kg/m3 .

A. 3000
B. 1500
C. 1200
D. 1400
Answer» D. 1400
5.

Total .. % of water by weight of water by weight of cement is required for complete hydration.

A. 40
B. 38
C. 42
D. 50
Answer» C. 42
6.

____ Cement is used for formwork that can be removed earlier and reused in other areas which save the cost of formwork.

A. Rapid Hardening Cement
B. Colored Cement
C. High Alumina Cement
D. Low Heat Cement
Answer» B. Colored Cement
7.

Which cement is used for works economic where considerations is predominant? Reservoirs, retaining walls, swimming pools, dams, bridges, piers etc.

A. Waterproof Portland Cement
B. Colored Cement
C. High Alumina Cement
D. Blast Furnace Slag Cement
Answer» E.
8.

Which cement is used for the construction of water-retaining structure like tanks, reservoirs, retaining walls, swimming pools, dams, bridges, piers etc?

A. Waterproof Portland cement
B. Colored Cement
C. High Alumina Cement
D. Low Heat Cement
Answer» B. Colored Cement
9.

Shrinkage is the reduction in the volume of a fresh hardened concrete exposed to ambient temp and humidity.

A. True
B. False
C. none
D. all
Answer» B. False
10.

Reduction in the quantity of mixing water which is possible by the use of plasticizers and admixture varies from

A. 1% to 5%
B. 5% to 15%
C. 15% to 25%
D. 25% to 35%
Answer» C. 15% to 25%
11.

Which of the following types of concrete mixture is most commonly used in precast concrete factories?

A. truck mounted mixture
B. pan type mixer
C. dual drum mixture
D. tilting drum mixture
Answer» C. dual drum mixture
12.

If the actual grading curve is steeper than the specified grading curve, it indicates an excess of ..particle size.

A. sand
B. coarser
C. medium
D. cement
Answer» D. cement
13.

The process of mixing, transporting, placing and compacting concrete should not take more than . min any case.

A. 90
B. 80
C. 70
D. 60
Answer» B. 80
14.

Compacting factor test should be made for concrete with maximum size of aggregate not exceeding 40 mm.

A. True
B. False
C. none
D. all
Answer» B. False
15.

In very low category of degree of workability determination by compacting factor will be more appropriate.

A. True
B. False
C. none
D. all
Answer» B. False
16.

ISI has specified full strength of concrete after

A. 7 days
B. 14 days
C. 21 days
D. 28 days
E. none of these.
Answer» F.
17.

'Ware house pack' of cement means

A. full capacity of the ware house
B. pressure exertion of the bags of upper layers
C. pressure compaction of the bags on lower layers
D. packing the ware house
E. none of these.
Answer» D. packing the ware house
18.

In the method of voids for determination of the quantity of cement paste, it is assumed that

A. Voids in coarse aggregates are filled by fine aggregates
B. Voids in fine aggregates are filled by the cement paste
C. Volume of fine aggregates is equal to total voids in coarse aggregates plus 10% extra
D. Volume of cement paste required is equal to total volume of voids in fine aggregates plus 15% extra
E. All the above.
Answer» F.
19.

If X, Y and Z are the fineness modulli of coarse, fine and combined aggregates, the percentage (P) of fine aggregates to combined aggregates, is

A. [A].
B. [B].
C. [C].
D. [D].
E. [E].
Answer» C. [C].
20.

Water required per bag of cement, is

A. 7 kg
B. 14 kg
C. 21 kg
D. 28 kg
E. 35 kg
Answer» F.
21.

Di-calcium silicate (C2S)

A. hydrates rapidly
B. generates less heat of hydration
C. hardens rapidly
D. provides less ultimate strength to cement
E. has less resistance to sulphate attack.
Answer» C. hardens rapidly
22.

The produce impermeable concrete

A. thorough mixing of concrete is required
B. proper compaction of concrete is required
C. proper curing of concrete is required
D. properly graded and non-porous aggregates are requied
E. all the above.
Answer» F.
23.

For a concrete mix 1:3:6 and water cement ratio 0.6 both by weight, the quantity of water required per bag, is

A. Constructionjoints are generally provided in positions subjected to least shear force
B. All the above.
C. 10 kg
D. 12 kg
Answer» D. 12 kg
24.

The entrained air in concrete

A. 10 kg
B. 12 kg
C. 14 kg
D. 15 kg.
Answer» B. 12 kg
25.

Pick up the incorrect statement applicable to the field test of good cement.

A. Water lubricates the mixture of gravel, sand and cement
B. Only a small quantity of water is required for hydration of cement
C. Strength of concrete structure largely depends upon its workability
D. All the above.
Answer» E.
26.

The ratio of the length to breadth of a wooden float, is

A. more liable to segregation
B. more liable to bleeding
C. more liable for surface scaling in frosty weather
D. none of these.
Answer» E.
27.

Ordinary concrete is not used for concrete grade

A. less cement in the concrete
B. proper concrete mix
C. presaturated aggregates
D. all the above.
Answer» E.
28.

The rock which is not calcareous, is :

A. Slump test
B. Minimum void method
C. Talbot Richard test.
D. lime stone
Answer» E.
29.

The aggregate impact value of the aggregate used in

A. 20°C
B. 23°C
C. 27 ± 2°C
D. building concrete is less than 45
Answer» E.
30.

Pick up the incorrect statement from the following. While performing preliminary test on concrete

A. 60 minutes
B. 75 minutes
C. 90 minutes.
D. proportions of the material and water should be the same as to be used at the work site
Answer» E.
31.

The minimum percentage of chemical ingredient of cement is that of

A. least weight for the given cement and aggregates
B. greatest weight for the given cement and aggregates
C. none of these.
D. magnesium oxide
Answer» B. greatest weight for the given cement and aggregates
32.

To hydrate 500kg of cement full water needed, is

A. Large size aggregates increase the workability due to lesser surface area
B. The slump of the concrete mix decreases due to an increase in temperature
C. All the above.
D. 100 kg
Answer» E.
33.

Saw dust can be rendered chemically inert by boiling it in water containing

A. ferrous sulphate
B. potassium chloride
C. ammonia
D. nitric acid
Answer» B. potassium chloride
34.

The high strength of rapid hardening cement at early stage, is due to its

A. lime
B. concrete.
C. finer grinding
D. burning at high temperature
Answer» D. burning at high temperature
35.

If 20 kg of coarse aggregate is sieved through 80 mm, 40 mm, 20 mm, 10 mm, 4.75 mm, 2.36 mm, 1.18 mm, 600 micron, 300 micron and 150 micron standard sieves and the weights retained are 0 kg, 2 kg, 8 kg, 6 kg, 4 kg respectively, the fineness modulus of the aggregate, is

A. lime stone
B. graphite.
C. 7.3
D. 7.35
Answer» D. 7.35
36.

Workability of concrete is measured by

A. 1 : 2 : 4 mix
B. 1 : 1.5 : 3 mix
C. none of these.
D. Vicat apparatus test
Answer» C. none of these.
37.

The light weight aggregates are obtained from

A. sedimentary rocks
B. metamorphic rocks
C. igneous rocks
D. volcanic source.
Answer» E.
38.

Pozzolana cement is used with confidence for construction of

A. impact value.
B. dams
C. massive foundations
D. abutments
Answer» E.
39.

The following proportion of the ingredients of concrete mix, is not in conformation to arbitrary method of proportioning

A. 4/5th of mean dimension
B. none of these.
C. 0.042384259259259
D. 0.043101851851852
Answer» E.
40.

Grading of sand causes great variation in

A. do not carry reinforcement across them
B. all the above.
C. workability of concrete
D. strength of concrete
Answer» E.
41.

A flaky aggregate is said to be elongated if its length is

A. equal to the mean size
B. twice the mean size
C. thrice the mean size
D. four times the mean size
Answer» C. thrice the mean size
42.

For the construction of the retaining structures, the type of concrete mix to be used, is

A. None of these.
B. 0.043819444444444
C. 0.043101851851852
D. 1 : : 3
Answer» D. 1 : : 3
43.

Joints in concrete structures, are provided

A. Both (c) and (d).
B. to reduce the tensile stresses likely to be developed due to evaporation of water
C. to minimise the change in the dimensions of the slab
D. to minimise the necessary cracking
Answer» E.
44.

The commercial name of white and coloured cement in India, is

A. none of these.
B. colocrete
C. rainbow cement
D. silvicrete
Answer» E.
45.

For batching 1:3:6 concrete mix by volume, the ingredients required per bag of 50 kg cement, are:

A. 0.7
B. 70 litres of sand and 120 litres of aggregates
C. 70 kg of sand and 140 litres of aggregates
D. 105 litres of sand and 140 litres of aggregates
Answer» E.
46.

According to Water-Cement Ratio Law, the strength of workable plastic concrete

A. depends upon the amount of water used in the mix
B. does not depend upon the quality of cement mixed with aggregates
C. does not depend upon the quanity of cement mixed with aggregates
D. all the above.
Answer» E.
47.

The process of proper and accurate measurement of concrete ingredients for uniformity of proportion, is known

A. 12 mm
B. grading
C. curing
D. mixing
Answer» E.
48.

For ensuring quality of concrete, use

A. none of these.
B. single sized aggegates
C. two sized aggregate
D. graded aggregates
Answer» D. graded aggregates
49.

An ideal ware house, is provided

A. water proof masonry walls
B. water proof roof
C. few windows which remain generally closed
D. 15 cm thick concrete floor laid on a dry course of soling
Answer» E.
50.

The type of aggregates not suitable for high strength concrete and for pavements subjected to tension, is

A. rounded aggregate
B. irregular aggregate
C. angular aggregate
D. flaky aggregate
Answer» B. irregular aggregate