Explore topic-wise MCQs in ENGINEERING SERVICES EXAMINATION (ESE).

This section includes 2171 Mcqs, each offering curated multiple-choice questions to sharpen your ENGINEERING SERVICES EXAMINATION (ESE) knowledge and support exam preparation. Choose a topic below to get started.

951.

To convert SR latch to D latch

A. connect both S and R to D
B. connect D to S directly and D to R through inverter
C. connect D to R directly and D to S through inverter
D. connect S to D and leave R open
Answer» C. connect D to R directly and D to S through inverter
952.

D/A converters are generally

A. weighted resistor network
B. binary ladder network
C. either (a) or (b)
D. neither (a) nor (b)
Answer» C. either (a) or (b)
953.

Assuming accumulator contain A 64 and the carry is set (1). What will accumulator (A) and carry (CY) contain after ANA A?

A. A 6 H, 1
B. A 6 H, 0
C. 00 H, 0
D. 00 H, 1
Answer» C. 00 H, 0
954.

A voltage DAC is generally slower than current DAC

A. because of more accuracy
B. because of higher resolution
C. because of response time of op-amp current to voltage converter
D. none of the above
Answer» D. none of the above
955.

Available multiplexer IC package can have a maximum of 8 inputs.

A. True
B. False
C. May be True or False
D. Can't say
Answer» C. May be True or False
956.

A counter displays a sequence of numbers. If a reading corresponds to the hexadecimal number F52E, the next two readings are respectively

A. F52F, F520
B. F530, F531
C. F52F, F530
D. F52F, F52G
Answer» D. F52F, F52G
957.

The digit F in hexadecimal system is equivalent to number __________ in decimal system.

A. 16
B. 15
C. 17
D. 8
Answer» C. 17
958.

Which device changes serial data to parallel data?

A. Counter
B. Multiplexer
C. Demultiplexer
D. Flip flop
Answer» D. Flip flop
959.

A 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000). Then, what will be input, if the output register shows 100111 at the end of conversion.

A. 5.85 V
B. 6 V
C. 5 V
D. 10 V
Answer» B. 6 V
960.

The number of accumulators in 6800 are

A. 2
B. 3
C. 1
D. 4
Answer» B. 3
961.

Out of SAM and RAM

A. access time in both does not depend on address location
B. in SAM access time depends on address location but not in RAM
C. in RAM access time depends on address location but not in SAM
D. in both the access time depends on storage location
Answer» C. in RAM access time depends on address location but not in SAM
962.

The figure of merit for a logic family is

A. gain band width product
B. (propagation delay time) (power dissipation)
C. (fan out) (power dissipation)
D. (noise margin) (power dissipation)
Answer» C. (fan out) (power dissipation)
963.

An 8 bit transistor register has output voltage of low-high-low-high-low-high-low-high. The decimal number stored is

A. 105
B. 95
C. 85
D. 75
Answer» D. 75
964.

A counter has a modulus of 10. The number of flip flops is

A. 10
B. 5
C. 4
D. 3
Answer» D. 3
965.

A digital system is required to amplify a binary encoded audio signal. The user should be able to control the gain of the amplifier from a minimum to a maximum in 100 increments. The minimum number of bits required to encode, in straight binary is,

A. 8
B. 6
C. 5
D. 7
Answer» E.
966.

Which has the lowest propagation delay time?

A. ECL
B. TTL
C. CMOS
D. PMOS
Answer» B. TTL
967.

A universal shift register can shift left or right.

A. True
B. False
C. May be True or False
D. Can't say
Answer» B. False
968.

Which of the following is not a specification of D/A and A/D converters?

A. Gain
B. Drift
C. Speed
D. Accuracy
Answer» B. Drift
969.

Computer virus is a piece of rough software of unknown origin that

A. copies itself like a breeding germ
B. spreads from one machine to another
C. eats away processing power
D. all of the above
Answer» E.
970.

Using 2's complement, the largest positive and negative number which can be stored with 8 bits are

A. +128 and -127
B. +128 and -128
C. +127 and -128
D. +127 and -127
Answer» D. +127 and -127
971.

What will be FSV in 2 bit BCD D/A converter is a weighted resistor type with ER = 1V, R = 1 MΩ and Rf = 10KΩ

A. 0.99 V
B. 0.9 V
C. 0.1 V
D. 0
Answer» B. 0.9 V
972.

In a 4 bit ripple counter using flip flops with tpd = 40 ns, the maximum frequency can be

A. 1.25 MHz
B. 3.25 MHz
C. 6.25 MHz
D. 12.5 MHz
Answer» D. 12.5 MHz
973.

An AND gate has two inputs A and B and one inhibit input 3, Output is 1 if

A. A = 1, B = 1, S = 1
B. A = 1, B = 1, S = 0
C. A = 1, B = 0, S = 1
D. A = 1, B = 0, S = 0
Answer» C. A = 1, B = 0, S = 1
974.

Which of them contains an organic fluid?

A. LED
B. LCD
C. Both LED and LCD
D. Neither LED nor LCD
Answer» C. Both LED and LCD
975.

In TTL the transistors are driven into and out of saturation.

A. True
B. False
C. May be True or False
D. Can't say
Answer» B. False
976.

Which memory does not require programming equipment?

A. RAM
B. EPROM
C. EEPROM
D. UVPROM
Answer» B. EPROM
977.

The number FF in hexadecimal system is equivalent to number __________ in decimal system.

A. 256
B. 255
C. 240
D. 239
Answer» C. 240
978.

110.11₂ x 110₂ = __________ ₁₀

A. 40.5
B. 30.5
C. 20.5
D. 10.5
Answer» B. 30.5
979.

If number of information bits is 4, the parity bits in Hamming code are located at bit positions __________ from the LSB.

A. 1, 2, 5
B. 1, 2, 4
C. 1, 2, 3
D. 1, 2
Answer» C. 1, 2, 3
980.

Which are the pending interrupts?

A. 5.5
B. 6.5
C. 7.5
D. None
Answer» D. None
981.

For a 4096 x 8 EPROM, the number of address lines is

A. 14
B. 12
C. 10
D. 8
Answer» C. 10
982.

Figure shows an 8-bit LED display. A light circle means that a LED is ON (binary 1) and a dark circle means a LED is OFF (binary 0). What is the decimal equivalent of the binary number displayed?

A. 100
B. 121
C. 144
D. 172
Answer» E.
983.

The logic circuit of the given figure realizes the function

A. A
B. B
C. C
D. D
Answer» B. B
984.

The binary equivalent of 4096.90625 is

A. 1000000000000.11101
B. 10000000000001.10101
C. 1000000000001.10001
D. 1000000000000.10011
Answer» B. 10000000000001.10101
985.

For wired AND connection we should use

A. TTL gates with active pull up
B. TTL gates with open collector
C. TTL gates without active pull up and with open collector
D. any of the above
Answer» D. any of the above
986.

For a depletion type NMOS, Vp = - 4 volts. For VGS = 0, 1D = 16 mA in the pinch off region of VDS. For VGS = - 2, the value of ID in the pinch off region of VDS is given by

A. 64 mA
B. 32 mA
C. 16 mA
D. 4 mA
Answer» E.
987.

The logic performed by the high-noise immunity logic circuit shown below is

A. OR
B. AND
C. NOR
D. NAND
Answer» E.
988.

(1001-10) is equal to

A. 7
B. (8)₈
C. (7)₄
D. (8)₄
Answer» B. (8)₈
989.

A(A̅ + B) =

A. A
B. A̅ B
C. AB
D. AB̅
Answer» D. AB̅
990.

Among the logic families, the family which can be used at very high frequency greater than 100 MHz in a 4 bit synchronous counter is

A. TTL
B. CMOS
C. ECL
D. TTLLS
Answer» D. TTLLS
991.

In parallel in-parallel out shift register all bits are loaded and read simultaneously.

A. True
B. False
C. May be True or False
D. Can't say
Answer» B. False
992.

A ripple counter has propagation delay.

A. True
B. False
C. May be True or False
D. Can't say
Answer» B. False
993.

The total number of input words for 4 input OR gate is

A. 20
B. 16
C. 12
D. 8
Answer» C. 12
994.

Which memory requires periodic recharging?

A. All ROMS
B. All RAMS
C. Static RAM
D. Dynamic RAM
Answer» E.
995.

A binary with a digits, all of which are unity has the value

A. n² - 1
B. 2ⁿ
C. 2ⁿ‾¹
D. 2ⁿ - 1
Answer» E.
996.

A 555 timer can be used as

A. an astable multivibrator
B. monostable multivibrator
C. frequency Divider only
D. any of the above
Answer» E.
997.

Assume that only x and y logic inputs are available. What is the minimum number of 2-input NAND gates required to implement x Ꚛ y?

A. 2
B. 3
C. 4
D. 5
Answer» D. 5
998.

In the assembler, which one of the following is required for variable name in symbol table?

A. Addresses
B. Values
C. Registers
D. Storage
Answer» D. Storage
999.

How many interrupts are there in 8085 microprocessor?

A. 4
B. 5
C. 6
D. 8
Answer» C. 6
1000.

What will be conversion rate for a counter type A/D converter contains a 4 bit binary ladder and a counter driven by a 2 MHz clock. Then conversion time

A. 125
B. 125 x 10³
C. 125 x 10⁶
D. None
Answer» C. 125 x 10⁶