You need to create an access list that will prevent hosts in the network range of 192.168.160.0 to 192.168.191.0 . Which of the following lists will you use?

access - list 10 deny 192.168.0.0 0.0.31.255

access - list 10 deny 192.168.160.0 255.255.224.0

access - list 10 deny 192.168.160.0 0.0.191.255

access - list 10 deny 192.168.160.0 0.0.31.255

You need to create an access list that will prevent hosts in the netwo

1.	You need to create an access list that will prevent hosts in the network range of 192.168.160.0 to 192.168.191.0 . Which of the following lists will you use?
A.	access - list 10 deny 192.168.160.0 255.255.224.0
B.	access - list 10 deny 192.168.160.0 0.0.191.255
C.	access - list 10 deny 192.168.160.0 0.0.31.255
D.	access - list 10 deny 192.168.0.0 0.0.31.255
Answer» D. access - list 10 deny 192.168.0.0 0.0.31.255

Discussion

No Comment Found

Related MCQs

You want to ping the loopback address of your IPv6 local host. What will you type?
You want to implement a network medium that is not susceptible to EMI. Which type of cabling should you use?
You type Router#sh ru and receive a % ambiguous command error. why did you receive this message?
You need to subnet a network that has 5 subnets, each wit at least 16 hosts. Which classful subnet mask would you use?
You need to stop DoS attacks in real time and have a log of anyone who has tried to attack your network. What should you do your network?
You need to create an access list that will prevent hosts in the network range of 192.168.160.0 to 192.168.191.0 . Which of the following lists will you use?
You need the IP address of the devices with which the router has established an adjacency. Also, the retransmit interval and the queue counts for the adjacent routers Â need to be Â checked. What command will display the required information?
You have the following binary number :10110111. What are the decimal and hexadecimal equivalents?
You have finished physically installing an access point on the ceiling of your office. At a minimum, which parameter must be configured on the access point in order to allow a wireless client to operate on it?
You get a call from a network administrator who tells you that he typed the following into his router:_x005F_x000D_ Router (config) #router ospf 1_x005F_x000D_ Router (config-router) # network 10.0.0.0. 255. 0.0.0 area 0_x005F_x000D_ He tells you he still can't see any routes in the routing table. What configuration error did the administrator make?

You need to create an access list that will prevent hosts in the network range of 192.168.160.0 to 192.168.191.0 . Which of the following lists will you use?

Discussion

No Comment Found

Related MCQs

Reply to Comment