Tolerances of form and position are typically not used to control stra – McqOptions

MCQOPTIONS

1.	Tolerances of form and position are typically not used to control straightness.
A.	1
B.
Answer» C.

Discussion

No Comment Found

Related MCQs

Allowance is the maximum clearance or minimum interference specified to achieve a fit between two mating parts.
Tolerances of form and position are typically not used to control straightness.
Large batches of parts may use statistical methods to control quality where a sample of parts is inspected.
Implied 90 degree angles typically have different general tolerances applied to them than other angles covered by a general note.
Datum surfaces and features are used as references to control other features.
Tolerance is the total amount a specific dimension is permitted to vary.
In reference to geometric tolerancing, the term "geometric" refers to forms such as planes, cylinders, and squares.
Increased precision makes parts less expensive to manufacture.
The ISO has its own system of preferred metric limits and fits.
Geometric dimensioning and tolerancing can simplify the inspection process.