Explore topic-wise MCQs in Technical Drawing.

This section includes 15 Mcqs, each offering curated multiple-choice questions to sharpen your Technical Drawing knowledge and support exam preparation. Choose a topic below to get started.

Explore topic-wise MCQs in Technical Drawing.

When arranging symbols, it is typically not necessary to leave blank spaces adjacent to symbols to allow for reference designations and notes.

Terminals or leads are frequently identified by colors or symbols, which should be indicated on the diagram.

Interrupted paths are not an acceptable method of simplifying a diagram.

Printed circuit boards are widely used and replace hand-wiring methods.

On electronic diagrams, it is typically not necessary to identify each separately replaceable part.

Symbols should conform to an internationally or nationally approved standard.

For clarity, draw sections of multi-element parts separately in a schematic.

Connecting lines for conductors are typically drawn horizontally or vertically to minimize bends and crossovers.

CAD component layout programs allow you to create the best possible parts placement.

Schematic and single-line diagrams should be arranged so that signal or transmission path from input to output proceeds in this fashion:

Switches and relays should be shown in this position with no operating force or applied energy:

This type of circuit is a semiconductor wafer or chip:

These items typically are not used in new designs, but are still common in high-power amplifiers:

On electronic diagrams, you should indicate grouped components by using dashed lines to enclose them in a box.

On typical electronic diagrams, these items need not be shown unless they are needed for clarification: