The position of the backfill lying above the horizontal plane at the – McqOptions

MCQOPTIONS

1.	The position of the backfill lying above the horizontal plane at the top of wall is called
A.	active state
B.	plasticity
C.	surcharge
D.	slip lines
Answer» D. slip lines

Discussion

No Comment Found

Related MCQs

What will be the co-efficient of passive earth pressure, at a depth of 8m in cohesion less soil sand with an angle of internal friction of 30° when the water rises to the ground level?
For storeyed building plinth area estimate is not prepared for each storey separately.
An culvert is normally a low profile culvert. It allows them to be installed without disturbing the causeway as it will span over the entire drainage width.
type of excavator is used for digging below, at or above operating level in a vertical range.
The term is used to denote a procedure of costing or valuing an item of work on the basis of actual labourers and materials required.
is the amount provided in the estimate and bill of quantities for some specialised work to be done by a specialised firm; whose details are not known at the time of preparing estimate.
A is a type of toilet that collects human faeces in a hole in the ground.
Cube rate estimate is less accurate as compared to the plinth area estimate as the height of the building is also compared.
A is developed using historical cost information that relates some software metric to the project cost.
Which of these reports involves the checking of a piece of equipment to see if it’s still in working condition?