The first step in creating a traditional technical drawing is to _____ – McqOptions

MCQOPTIONS

1.	The first step in creating a traditional technical drawing is to ________.
A.	draw a series of guide lines
B.	set up the miter line
C.	align the paper so that it will be positioned square to the parallel bar
D.	sharpen the leads in the technical pens
Answer» D. sharpen the leads in the technical pens

Discussion

No Comment Found

Related MCQs

Referring to the fractional inches to decimal inches to millimeter conversion chart on page 55 what is the equivalent mm measurement of / inch.
Every drafter and engineer continues to utilize both the architect and engineer's scales.
A drafter can use the 45 degree triangle to draw a 30 degree line.
A 15 degree line can be easily created by arranging both the 45 degree and 30/60 degree triangles.
Prior to the development of computer aided drafting, drafters relied on drawing boards, paper, and pencils to create technical drawings.
An engineer's scale would be used to measure lines on a drawing where the scale factor reads ________.
The parallel straight edge can be used for aligning the paper as well as drawing horizontal lines.
The first step in creating a traditional technical drawing is to ________.
A line to be drawn perpendicular to a horizontal line can only be drawn with a 45 degree triangle.
When using a technical pencil to create a drawing the drafter would usually select a soft lead to create a very light line.