Part 1 represents_________$ – McqOptions

MCQOPTIONS

1.	Part 1 represents_________$
A.	inlet pipe
B.	well
C.	drainage pipe
D.	outlet pipe
Answer» C. drainage pipe

Discussion

No Comment Found

Related MCQs

A commercially manufactured, vermin-proof _________ is the only type of cap designed to keep animals, insects and contaminants from entering your well.
There are two primary methods of drilling cable tool and ________
__________ wells are constructed when low yielding groundwater sources are found relatively close to the surface, usually under 30 m (100 ft.). These are constructed using a rotary bucket auger.
In the following figure, Part 2 represents?
In the following figure, Part 3 represents?
In the following figure, Part 1 represents?
Sealing the well protects the well’s producing zone from contamination.
Drilled wells are smaller in diameter, usually ranging from 10-20 cm (4-8 in.).
Water wells typically range from 3 to 18 metres (10–60 ft) deep, but in some areas can go deeper than 200 metre.
Production or pumping wells, are often smaller diameter wells used to monitor the hydraulic head or sample the groundwater for chemical constituents.