In the virtual work method, the virtual quantity is_________________? – McqOptions

MCQOPTIONS

1.	In the virtual work method, the virtual quantity is_________________?
A.	displacement
B.	load
C.	slope
D.	moment
Answer» B. load

Discussion

No Comment Found

Related MCQs

When a load is transferred through one surface to another surface in contact, the stress is known as
Working shear stress on the gross area of a rivet as recommended by Indian Standards, is
If N is the number of rivets in the joint, the strength of a riveted joint against shearing of rivets, is given by
The economical depth d of a web plate in which allowable bearing stress is fb, and the maximum bending moment is M, as suggested by Rawater and Clark, is
The strength of ISA 125 = 75 10 mm used as a tie member with its longer leg connected at the ends by 27 mm diameter rivets, is
As per IS: 800, in the plastic design, which of the following pairs are correctly matched? Working Loads Load factor(i) Dead load 1.7(ii) Dead Load + imposed load 1.7(iii) Dead load + load due to wind or 1.3 seismic forces(iv) Dead load + imposed load + load 1.7 due to wind or seismic forces Of these statements
If the thickness of plate to be connected by a rivet is 16 mm, then suitable size of rivet as per Unwin's formula will be
Maximum permissible slenderness ratio of a member normally acting as a tie in a roof truss, is
The least permissible clear dimension of the web of thickness t in the panel of a plate girder, is restricted to
When the bolts are subjected to reversal of stresses, the most suitable type of bolt is