MCQOPTIONS
Bookmark
Saved Bookmarks
→
ENGINEERING SERVICES EXAMINATION (ESE)
→
ESE - 2018
→
Hypoid gears are based on surfaces that are parabo...
1.
Hypoid gears are based on surfaces that are paraboloids of revolution.
A.
true
B.
false
Answer» C.
Show Answer
Discussion
No Comment Found
Post Comment
Related MCQs
5 SELECTION OF ROLLING CONTACT BEARINGS
A single transverse weld is preferred over double transverse fillet weld.
In hypoid bevel gears, shafts may continue past each other.
There are common types of bevel gears.
Which of the following cannot take radial load?
Which of the following isn’t the property of taper roller?
In angular contact bearings, bearings are required to take thrust load in both directions.
Deep groove ball bearings creates a lot of noise.
A bearing supports the load acting along the axis of the shaft.
In a four stroke cycle engine camshaft revolves at the crank speed.
Reply to Comment
×
Name
*
Email
*
Comment
*
Submit Reply
Your experience on this site will be improved by allowing cookies. Read
Cookie Policy
Reject
Allow cookies
