For which of the following design factor of – McqOptions

MCQOPTIONS

Saved Bookmarks

→ ENGINEERING SERVICES EXAMINATION (ESE)
→ ESE - 2018
→ For which of the following design factor of

1.	For which of the following design factor of
A.	0.1
B.	1
C.	2 d) 0.9
Answer» D.

Discussion

No Comment Found

Related MCQs

5 SELECTION OF ROLLING CONTACT BEARINGS
A single transverse weld is preferred over double transverse fillet weld.
In hypoid bevel gears, shafts may continue past each other.
There are common types of bevel gears.
Which of the following cannot take radial load?
Which of the following isn’t the property of taper roller?
In angular contact bearings, bearings are required to take thrust load in both directions.
Deep groove ball bearings creates a lot of noise.
A bearing supports the load acting along the axis of the shaft.
In a four stroke cycle engine camshaft revolves at the crank speed.

Related Topics

ESE - 2018

ESE - 2017

ESE - 2016

Building Materials

Solid Mechanics

Structural Analysis

Design of Steel Structures

Design of Concrete and Masonry structures

Construction Practice, Planning and Management

Hydrology and Water Resources Engineering

Recent Visits

Reply to Comment

Name *

Email *

Comment *

© Copyright 2025 McqOptions. All rights reserved.

Terms & Conditions
Privacy Policy
Disclaimer
Contact Us