Drafters do not need to worry about the number of decimal places used – McqOptions

MCQOPTIONS

1.	Drafters do not need to worry about the number of decimal places used on dimensioning a technical drawing.
A.	1
B.
Answer» C.

Discussion

No Comment Found

Related MCQs

Drafters do not need to worry about the number of decimal places used on dimensioning a technical drawing.
An assembly drawing is intended to illustrate a single mechanical part.
BOM stands for Bill of Materials.
Designers utilize several methods for solving mechanical design problems including brainstorming ideas.
The mechanical engineering industry relies on complex mechanical drawings that are often referred to as working drawings.
It is customary for the first sheet of a working drawing set to include ________.
Mechanical designers can expect to make several revisions to a design before it is finalized.
In order to create an accurate assembly drawing the drafter should create the ________ drawings first.
Mechanical drafters can revise any drawing at any time without tracking those changes.
The thread note for a typical bolt will include the ________.