MCQOPTIONS
Bookmark
Saved Bookmarks
→
BITSAT
→
BITSAT - 2018
→
CMRR for an Op-amp should be
1.
CMRR for an Op-amp should be
A.
As large as possible
B.
Close to zero
C.
Close to unity
D.
As small as possible
Answer» B. Close to zero
Show Answer
Discussion
No Comment Found
Post Comment
Related MCQs
If a regulator IC provides lower than input then the converter is known as ____.
Circuit used for production of delay is
If a UJT has an internal resistance 2k ohm at RB1 and 1 k ohm at RB2, what is its intrinsic stand-off ratio?
An oscillator circuit which is meant for converting sine wave signal into square wave signal is called a
Conformal coating is done in PCB assemblies to
For an NPN transistor, if the Base Emitter junction is in forward biased and Base collector junction is in reverse biased, the mode of operation is:
In a UJT, the emitter terminal is:
In LED, light is emitted because
Class – B push – pull amplifiers have following type of prominent distortion
Identify the Converter topologies from the figures given below:
Reply to Comment
×
Name
*
Email
*
Comment
*
Submit Reply
Your experience on this site will be improved by allowing cookies. Read
Cookie Policy
Reject
Allow cookies