A pipe consisting of several pipes of varying diameters and lengths, m – McqOptions

MCQOPTIONS

1.	A pipe consisting of several pipes of varying diameters and lengths, may be replaced by an equivalent pipe of diameter D of length
A.	[A].
B.	[B].
C.	[C].
D.	[D].
Answer» D. [D].

Discussion

No Comment Found

Related MCQs

The Empirical formula for discharge over large rectangular weirs, is known as
A tank 4m x 3m x 2m containing an oil of specific gravity 0.83 is moved with an acceleration /2 m sec. The ratio of the pressures at its bottom when it is moving vertically up and down, is
The time required to close a valve gradually is (where is the length of pipe and = velocity of pressure wave)
If is the difference of liquid levels on two sides of an orifice (width , depth ), the discharge through the orifice will be
To ensure that water does not rise more than 100 cm above the crest, for a discharge of 5.00 m/sec, the length of water will be
The value of kinetic energy correction factor () for a laminar flow through a circular pipe, is
The formula = x x x where was suggested by :
The minimum specific energy of flow of water in open channel is : (where is the critical depth)
A nozzle is fitted at the end of a pipe whose length is 320 m and diameter is 10 cm. If the value of = 0.01, the diameter of the nozzle for the maximum transmission of power through the nozzle is
In two dimensional flow the components of velocity are given by = ; = . The stream lines will be