A direct shear test was conducted on a cohesionless soil (c = 0) specimen under a normal stress of 200 kN/m2. The specimen failed at a shear stress of 100 kN/m2. The angle of internal friction of the soil (degrees) is

A direct shear test was conducted on a cohesionless soil (c = 0) speci

1.	A direct shear test was conducted on a cohesionless soil (c = 0) specimen under a normal stress of 200 kN/m2. The specimen failed at a shear stress of 100 kN/m2. The angle of internal friction of the soil (degrees) is
A.	26.6
B.	29.5
C.	30
D.	32.6
Answer» B. 29.5

Discussion

No Comment Found

Related MCQs

A borrow pit soil has a dry density of 17 kN/m. How many cubic meters of this soil will be required to construct an embankment of 100 m volume with a dry density of 16 kN/m.
The ultimate bearing capacity of a soil is 300 kN/m. The depth of foundation is 1 m and unit weight of soil is 20 kN/m. Choosing a factor of safety of 2.5, the net safe bearing cacpacity is
The flow of water (mass density = 1000 kg/m and kinematic viscosity = 10 m/s) in a commercial pipe, having equivalent roughness as 0.12 mm, yields an average shear stress at the pipe boundary = 600 N/m. The value of /δ' (δ' being the thickness of laminar sub-layer) for this pipe is
Water flows at a rate of 10 m/s in a rectangular channel 3 m wide. The critical depth of flow is
The span () to be loaded uniformly for maximum positive (upward) reaction at support , as shown in the figure below, is (are)
The deflection of a cantilever beam at free end applied with a moment at the same point is :
A circular sewer 2 m diameter has to carry a discharge of 2 m/s when flowing nearly full. What is the minmum required slope to initiate the flow ? (Assume Manning's = 0.015)
For a highway with design speed of 100 kmph, the safe overtaking sight distance is (assume accelerations as 0.53 m/sec)
An isolated beam is used as a walkway. The beam is simply supported with an effective span of 6 m. The effective width of flange, for the cross-section shown in the below figure is
The stress-strain diagram for two materials A and B is shown below. The following statements are made based on this diagram : With reference to the above statements, which of the following applies ?

A direct shear test was conducted on a cohesionless soil (c = 0) specimen under a normal stress of 200 kN/m2. The specimen failed at a shear stress of 100 kN/m2. The angle of internal friction of the soil (degrees) is

Discussion

No Comment Found

Related MCQs

Reply to Comment