Explore topic-wise MCQs in Engineering.

The purpose of a riser is to

Metal patterns are used for

The instrument which has all the features of try-square, bevel protractor, rule and scriber, is

When a hole or cavity to be cored is not in line with the parting surface, then a __________ is used.

The bloom is smaller than a billet.

In average work, the tolerance produced by investment casting method is

The low pressure acetylene is produced at the welding site by the chemical reaction between water and calcium carbonate.

The ferrous metals require more machining allowance than non-ferrous metals.

In a four high rolling mill, there are four rolls out of which

When a pattern is made in three parts, the bottom part is known as a cope.

In __________ welding, the weld may be made either from left to right or from right to left.

The algebraic difference between the minimum limit and the basic size is called

Blanking and piercing operations can be performed simultaneously in a

In welding copper alloys with TIG arc welding

The temperature of oxy-hydrogen flame is __________ oxy-acetylene flame.

In a hot chamber die casting machine

The electrodes used in spot welding have a tip of

A pattern maker's shrinkage rule considers

The tolerance produced by shell moulding process of casting is

In submerged arc welding, an arc is produced between a

In shielded arc welding

In a die casting method, the molten metal is forced into mould under high pressure.

In a centrifugal casting method, the impurities are collected in the centre of the casting.

Which of the following methods can be used for manufacturing 2 metre long seamless metallic tubes?

A saw which cuts wood during the return stroke of the saw is known as

The chisel used for cutting key ways is

The temperature at which the new grains are formed in the metal is called

Thread rolling is restricted to

The valve overlap in four stroke petrol engines is approximately

In sheet metal blanking, shear is provided on punches and dies so that

In arc welding, the electric arc is produced between the work and the electrode by

The petrol engines are also known as

In a centrifugal casting method

Which of the following indicates a multigrade oil ?

The natural gas is compressed in a CNG cylinder at a pressure of

The cetane rating of Diesel fuel is in the order of

The coefficient of friction for the clutch facing is approximately

The component that connects the steering rack to the knuckles is

The most commonly used supplementary restraint system (SRS) component is

The air gap between the central electrode and ground (or side) electrode of a spark plug is around

The cetane number of a Diesel fuel is a measure of

The aluminium alloy is used in cylinder blocks because

In a fuel injection system, the electronic control module (ECM) calculates the optimum fuel-injection volume for the engine condition based on the data received from the sensors, and injects this volume of fuel into the intake manifold at the optimum timing.

The tilting of the front wheels away from the vertical, when viewed from the front of the car, is called

The main function of the tread pattern on tyre is that

The compression ratio in petrol engine is kept less than in Diesel engine because

The information provided by the oxygen (O₂) sensor to the feedback control system is about the

The diagram which shows the correct crank positions corresponding to the opening and closing of the valves, is known as

In automobiles G.V.W. refers to

The firing order for an in-line four cylinder I.C. engine is