When dimensioning piping drawings, you give the lengths of all runs of – McqOptions

MCQOPTIONS

1.	When dimensioning piping drawings, you give the lengths of all runs of this type:
A.	Straight
B.	Angular
C.	Filleted
D.	Transverse
Answer» B. Angular

Discussion

No Comment Found

Related MCQs

Single-line drawings show the centerline of the pipe.
When dimensioning piping drawings, it is not necessary to indicate the size of each pipe.
Copper tubing is not suitable for process work, for plumbing, or heating systems.
In a developed piping drawing, horizontal pipes may be revolved into the vertical plane so the entire installation can be shown on one plane.
Brass and copper pipe is used in plumbing for supply, soil, waste, drain, and vent lines.
Axonometric drawings are seldom used in piping drawings.
Copper pipe is brittle, and settling can cause fracture unless the joints are sufficiently flexible.
Valves are used to stop or regulate the flow of fluids in a pipeline.
This type of pipe is commonly used for water or gas service, and also as soil pipe:
A wide variety of plastic pipe, both rigid and flexible, is used in construction.