WHEN_A_CUT_IS_10_MINUTES_AND_THE_CALCULATED_PROCESS_WAS_60_MINUTES_AT_ – McqOptions

MCQOPTIONS

1.	WHEN_A_CUT_IS_10_MINUTES_AND_THE_CALCULATED_PROCESS_WAS_60_MINUTES_AT_116_DEG_C,_THEN_THE_CORRECTED_PROCESS_TIME_IS______?$
A.	60 minutes
B.	55 minutes
C.	55.8 minutes
D.	54.2 minutes
Answer» D. 54.2 minutes

Discussion

No Comment Found

Related MCQs

WHEN_A_CUT_IS_10_MINUTES_AND_THE_CALCULATED_PROCESS_WAS_60_MINUTES_AT_116_DEG_C,_THEN_THE_CORRECTED_PROCESS_TIME_IS______?$
For heat penetration considerations for safe processing schedule, the slowest cooling and the fastest heating curves are used to calculate lethal effect of the process.$
Which_of_the_following_factor_does_safe_processing_schedule_depend_upon?$
Statement 1: Corrosion of cans is more complicated than that of tin and iron alone. Depending on whether the tin forms a complex or not, it acts as the anode or cathode.
Statement 1: The swelling of cans takes place due to the release of hydrogen gas.
Statement 1: In low and medium acid foods, spore forming organisms are observed.
Which of the following is required for calculation of process time by Ball‚Äö√Ñ√∂‚àö√ë‚àö¬•s method?$
With respect to thermal death time curve, D value is the unit defined as the combination of time and temperature to bring about a 90% reduction in spoilage organisms.
Statement 1: In thermal death time curve, after plotting C/t values from it, C value should be equal to C<sub>o</sub> value.
By plotting the C/t values obtained from a thermal death time curve, a curve is obtained. How is the lethal value obtained from this curve?