Which of the following is required for calculation of process time by – McqOptions

MCQOPTIONS

1.	Which of the following is required for calculation of process time by Ball‚Äö√Ñ√∂‚àö√ë‚àö¬•s method?$
A.	C and z value of thermal death time curve
B.	Cold point of the container
C.	Number of degrees which exist between the retort temperature and the maximum temperature
D.	All of the mentioned
Answer» E.

Discussion

No Comment Found

Related MCQs

WHEN_A_CUT_IS_10_MINUTES_AND_THE_CALCULATED_PROCESS_WAS_60_MINUTES_AT_116_DEG_C,_THEN_THE_CORRECTED_PROCESS_TIME_IS______?$
For heat penetration considerations for safe processing schedule, the slowest cooling and the fastest heating curves are used to calculate lethal effect of the process.$
Which_of_the_following_factor_does_safe_processing_schedule_depend_upon?$
Statement 1: Corrosion of cans is more complicated than that of tin and iron alone. Depending on whether the tin forms a complex or not, it acts as the anode or cathode.
Statement 1: The swelling of cans takes place due to the release of hydrogen gas.
Statement 1: In low and medium acid foods, spore forming organisms are observed.
Which of the following is required for calculation of process time by Ball‚Äö√Ñ√∂‚àö√ë‚àö¬•s method?$
With respect to thermal death time curve, D value is the unit defined as the combination of time and temperature to bring about a 90% reduction in spoilage organisms.
Statement 1: In thermal death time curve, after plotting C/t values from it, C value should be equal to Co value.
By plotting the C/t values obtained from a thermal death time curve, a curve is obtained. How is the lethal value obtained from this curve?