What should be the value of transconductance, if N-channel E-MOSFET is biased in saturation region with the conduction parameter (k) = 0.836 mA/ V and drain current (I) = 1.5 mA?

What should be the value of transconductance, if N-channel E-MOSFET is

1.	What should be the value of transconductance, if N-channel E-MOSFET is biased in saturation region with the conduction parameter (k) = 0.836 mA/ V and drain current (I) = 1.5 mA?
A.	1 mA/V
B.	1.5 mA/V
C.	2.23 mA/V
D.	4.23 mA/V
Answer» D. 4.23 mA/V

Discussion

No Comment Found

Related MCQs

Which among the below mentioned implementation strategies is/are precise to obtain an AC equivalent circuit of MOSFET?A. Replacement of all capacitors by open circuitsB. Replacement of all capacitors by short circuitsC. Setting of all DC voltages to zeroD. Setting of all DC voltages to unity
What should be the value of transconductance, if N-channel E-MOSFET is biased in saturation region with the conduction parameter (k) = 0.836 mA/ V and drain current (I) = 1.5 mA?
What would happen if 180 phase shifted signal between input voltage (Vi) and drain-to-source voltage (V) will be passed through the output coupling capacitor during the operation of MOSFET as an amplifier?
Which among the below stated consequences occur in the negative half-cycle during the operation of MOSFET as an amplifier?
The output signal generated corresponding to the magnified input signal by a linear amplifier is _________A. Larger in size B. Smaller in size C. Similar in shape as that of input signalD. Different in shape as that of input signal
Which type of breakdown can be prevented by adopting a reverse-biasedgate protecting diode on input side of MOSFET?
Which is/are the major drawback/s of including an additionaln__drift layer in a typical n-p-n bipolar power transistor?
On which factor does the current gain ( ) of power transistor depend?
The breakdown voltage V or V in power transistor is the maximum voltage between collector and emitter with _________
Which among the following are specifically the advantages of bipolar design technology?A. High input resistance at low frequenciesB. Zero input bias currentC. High voltage gainD. High value of transconductance

What should be the value of transconductance, if N-channel E-MOSFET is biased in saturation region with the conduction parameter (k) = 0.836 mA/ V and drain current (I) = 1.5 mA?

Discussion

No Comment Found

Related MCQs

Reply to Comment