Typically the creep rate is measured in which unit? – McqOptions

MCQOPTIONS

1.	Typically the creep rate is measured in which unit?
A.	Length/minutes
B.	Load/length
C.	Percentage change of length/hour
D.	Percentage change of length/percentage change of time
Answer» D. Percentage change of length/percentage change of time

Discussion

No Comment Found

Related MCQs

The slip bands inside a grain during creep was first observed by which instrument?
The formation of sub-grain structure inside the lattice is a phenomena observed in the high-temperature creep. The number of new sub-grain formed are highest in which stage of creep?
The slip band produced at higher temperature are _______ and ________ spaced than for a room temperature deformation.
In aluminium the creep occurs by slip on the _______ planes.
The large-grained aluminum is most suitable for creep related study.
The change in the slope of stress-rupture line is not due to _____________
The creep test and the stress-rupture test are the same things representing the same type of curve at equal stresses.
Typically the creep rate is measured in which unit?