The thickness of aluminum sheet is specified to be of 6±2 mm. The Upper SpecificationLimit and Lower Specification Limit for the sheet are:

The thickness of aluminum sheet is specified to be of 6±2 mm. The Upp

1.	The thickness of aluminum sheet is specified to be of 6±2 mm. The Upper SpecificationLimit and Lower Specification Limit for the sheet are:
A.	4mm, 8mm
B.	8mm, 4mm
C.	6mm, 8mm
D.	4mm, 6mm
Answer» C. 6mm, 8mm

Discussion

No Comment Found

Related MCQs

Responsibility within the project for quality must be defined and promulgated to everyone contributing to the end product. First and foremost, the ______________ has the ultimate responsibility for conformance to requirements when provided with the tools, skills, knowledge, and opportunities.
The main aim of QFD is to
Which of the following is least likely to contribute to developing an effectiveproject team supportive of quality?
In the area of quality, project managers are struggling with the training and indoctrination of individuals in the need to do the work right the first time to conform to the requirement. Occasionally, the project manager will discover an individual, either in the planning or actual work, doing more than is called for in the specification. These individuals need training to reduce the level of "over building" because ______________.
A researcher conducted a 2 x 2 completely repeated measures factorial design and planned15 participants in each condition. How many participants would be required to conduct this experiment?
The key process input variables (KPIV) and key process output variables are developedduring the ______________ phase.
The treatment mean square (MSTR), Mean Square Error (MSE). If the true means of the kpopulations are equal, then MSTR/MSE should be:
Which of the following statements best characterizes the quality management practice called benchmarking?
A fundamental tenet of modern quality management holds that quality is mostlikely to be achieved:
Which of the following is not a type of attribute chart?

The thickness of aluminum sheet is specified to be of 6±2 mm. The Upper SpecificationLimit and Lower Specification Limit for the sheet are:

Discussion

No Comment Found

Related MCQs

Reply to Comment