The J integral method is used for the _______________ materials. – McqOptions

MCQOPTIONS

1.	The J integral method is used for the _______________ materials.
A.	high strength plastic materials
B.	low strength ductile material
C.	low strength brittle material
D.	high strength brittle material
Answer» C. low strength brittle material

Discussion

No Comment Found

Related MCQs

According to Irwin’s theory of crack resistance, the failure occurs when the rate of change of __________ release rate is equal to the rate of change of _______________ to the crack growth.
The R-curve is used to calculate the _______________ to fracture of the material during slow and stable crack propagation.
For the evaluation of J-integral value from the compact tension specimen, the amount of J in the below-shown sample is equal to __________Where A = area under the load vs. displacement curveb=W-aB=Specimen thickness
If the crack length is doubled than the original value, the potential energy of the J integral will change by a factor of ____
The value of J integral in potential energy term is written as J=dUo/da=K2/E’. The value of E’ in case of plane stress is equal to ______ (where v is the poison’s ratio).
The J-Integral is interpreted as the potential energy difference between the two identically loaded sample having slightly different crack lengths. Mathematically it can be written as __________
According to the J-Integral, the fracture occurs when the J integral value reaches a critical value. The value of J is equal to____________
The J integral is the path-dependent method.
The J integral method is used for the _______________ materials.
The geometry of the plastic zone in front of a crack tip is shown in the following figure.