The fretting is the process of ____________ – McqOptions

MCQOPTIONS

1.	The fretting is the process of ____________
A.	corrosion due to water
B.	relative motion between 2 metal causing the corrosion
C.	corrosion due to air
D.	fatigue due to excessive stress
Answer» C. corrosion due to air

Discussion

No Comment Found

Related MCQs

At higher temperature, if higher frequency of stress cycle is applied on the material, fracture will be ___________ and at lower frequency of stress, the fracture will be ___________
The fatigue strength of the material ___________ as the grain decreases.
At any given temperature, the creep will __________ with increasing mean stress.
The fatigue strength of the metal ____________ with increasing temperature.
As the temperature decreases, there is a sudden change in the fatigue limit of the material, similar to what has been observed in the ductile to brittle transition.
The fretting is the process of ____________
The stainless steel components are coated with _________ to control the fatigue corrosion.
The number of pits generated on the surface of the material under fatigue corrosion are ________ than the number of pits on the surface of the same sample when it is tested only under corrosion environment.
Is it possible that the material which shows the fatigue limit in normal environment does not show any endurance limit in a corrosive environment.
Which one of the following is only present in the corrosion fatigue?