The factor for deciding the type of sleeper, is

1.	The factor for deciding the type of sleeper, is
A.	easy fixing and removal of rails
B.	provision of sufficient bearing area for rails
C.	initial and maintenance costs
D.	strength to act as a beam under loads
E.	all the above.
Answer» F.

Discussion

No Comment Found

Related MCQs

If is gauge distance and a is crossing, the distance between the nose of acute crossing and nose of obtuse crossing of a rail diamond, measured along the rail not forming the diamond, is
If is the distance between the parallel sidings and α is the angle of crossing, the distance between the noses of crossing measured parallel to the main track, is
If is the distance between the parallel sidings and β is the limiting angle of crossings, the distance between the noses of crossing measured parallel to the main track, is
If is the distance between the parallel sidings and α is the angle of crossing, the distance between the noses of crossing measured parallel to the gathering line, is
If α is switch angle and is radius of the turnout, the length of the tongue rail, is
On a straight railway track, absolute levels at point on two rails are 100.550 m and 100.530 m and the absolute levels at point B 100 m apart are 100.585 m and 100.515 m respectively, the value of twist of rails per metre run, is
Safe speed () on a curve of radius 970 metres provided with two transition curves on Board Gauge track, is
If absolute levels of rails at the consecutive axles , , and separated by 1.8 metres are 100.505 m, 100.530 m, and 100.525 m respectively, the unevenness of rails, is
If S is the switch angle and α is diamond angle, r is the radius of slip, the distance between middle point slip and the nose of obtuse crossing, is
If D is the distance between the parallel sidings and β is the limiting angle of crossings, the distance between the noses of crossing measured parallel to the main track, is

The factor for deciding the type of sleeper, is

Discussion

No Comment Found

Related MCQs

Reply to Comment