The displacement flux density at a point on the surface of a perfect c – McqOptions

MCQOPTIONS

1.	The displacement flux density at a point on the surface of a perfect conductor is D = 2(ax - √3 az)c/m² pointing away from the surface. The charge density at that point c/m² will be
A.	2
B.	- 2
C.	4
D.	- 4
Answer» D. - 4

Discussion

No Comment Found

Related MCQs

A conductor carries 125 amperes of current under 60° to a magnetic field of 1.1 tesla.The force on the conductor will be nearly
When a dielectric slab is introduced in a parallel plate capacitor, the potential differencebetween plates will
If the sheet of a bakelite is inserted between the plates of an air capacitor, thecapacitance will
The working of a meter is based on the use of a permanent magnet. In order to protectthe meter functioning from stray magnetic fields
at a point may be defined as equal to the lines of force passing normally through a unitcross section at that point.
Three capacitors each of the capacity C are given. The resultant capacity 2/3 Ccan be obtained by using them
Two infinitely long parallel conductors in vacuum anf' separated 1 metre between centres >rhen a current of 1 ampere flows thn. ugh each conductor, produce on each otLer a force of
A coil is wound on iron core which carries current I. The self-induced voltage in the coilis not affected by
The time constant and R-C circuit may also be defined as the time during which thecharging current falls to ______ percent of its initial maximum value,
A coil induces 350 mV when the current changes at the rate of 1 A/s. The value ofinductance is