The creep in a belt drive is due to the – McqOptions

MCQOPTIONS

1.	The creep in a belt drive is due to the
A.	material of the pulleys
B.	material of the belt
C.	unequal size of the pulleys
D.	unequal tension in tight and slack sides of the belt
Answer» E.

Discussion

No Comment Found

Related MCQs

In order to have a good grip on the pulley, the V-belt should touch the bottom of the groove in the pulley.
Which of the following statements are correct regarding power transmission through V-belts?(i) V-belts are used at the high-speed end.(ii) V-belts are used at the low-speed end.(iii) V-belts are of standard lengths.(iv) V-angles of pulleys and belts are standardized.Select the correct answer using the code given below.
In order to have a good grip on the pulley, the V-belt should touch the bottom of the groove in the pulley?
The creep in a belt drive is due to the
Which of the following statements are correct regarding power transmission through V-belts?
The wire ropes make contact at
A V-belt designated by A-914-50 denotes
The groove angle of the pulley for V-belt drive is usually
The V-belts are particularly suitable for _____________ drives.
The included angle for the V-belt is usually