A V-belt designated by A-914-50 denotes – McqOptions

MCQOPTIONS

1.	A V-belt designated by A-914-50 denotes
A.	a standard belt
B.	an oversize belt
C.	an undersize belt
D.	none of the mentioned
Answer» B. an oversize belt

Discussion

No Comment Found

Related MCQs

In order to have a good grip on the pulley, the V-belt should touch the bottom of the groove in the pulley.
Which of the following statements are correct regarding power transmission through V-belts?(i) V-belts are used at the high-speed end.(ii) V-belts are used at the low-speed end.(iii) V-belts are of standard lengths.(iv) V-angles of pulleys and belts are standardized.Select the correct answer using the code given below.
In order to have a good grip on the pulley, the V-belt should touch the bottom of the groove in the pulley?
The creep in a belt drive is due to the
Which of the following statements are correct regarding power transmission through V-belts?
The wire ropes make contact at
A V-belt designated by A-914-50 denotes
The groove angle of the pulley for V-belt drive is usually
The V-belts are particularly suitable for _____________ drives.
The included angle for the V-belt is usually