Sensitivity to total sulphur by Flame-photometric detector is which o – McqOptions

MCQOPTIONS

1.	Sensitivity to total sulphur by Flame-photometric detector is which of the following levels?
A.	0.1 ppm
B.	1 ppm
C.	2 ppm
D.	0.01 ppm
Answer» E.

Discussion

No Comment Found

Related MCQs

In the conductivitimetric method, to measure the conductivity of the cell, 5V ___________ is applied across the electrodes.
In conductivitimetric method, the concentration of sulphur dioxide is proportional to which of the following parameters of the saw-tooth waveform?
Given below, is the diagram of Ultraviolet Fluorescence method. Identify the unmarked component.
Which of the following is the wavelength of the radiation generated when an air stream containing sulphur dioxide is burned in a hydrogen-rich flame?
Which of the following methods are not used for the measurement of sulphur dioxide?
Sensitivity to total sulphur by Flame-photometric detector is which of the following levels?
Which of the following is the detection limit of the coulometric method used for measurement of sulphur dioxide?
Which of the following materials are used as electrodes in the coulometric method for the measurement of sulphur dioxide?
Which of the following is not true about using gas chromatography for measuring pollutants in the air?
Which of the following are not the characteristics of colorimetry method used to monitor sulphur dioxide?