Rj is the ____________ – McqOptions

MCQOPTIONS

1.	Rj is the ____________
A.	Target value for range
B.	Target value for ratios
C.	Result of jth part
D.	Ratio of jth part
Answer» B. Target value for ratios

Discussion

No Comment Found

Related MCQs

The DNOM approach does not need the measurements to be taken at all.
The standardized control chart approach for short production runs can only be applied on variable control charts.
Which of these is correct target value for standardized control chart for fraction nonconforming for shorter production runs?
Which of these is true according to Farnum?
According to Farnum, the coefficient of variation is _____________
Standardized control chart approach for short production runs was presented by ____________
Tj stands for __________
Rj is the ____________
The term Mi, which is used in the expression of the standard variable used in standardized x bar charts for short production runs, is defined as ___________
Which of these has the same difference between the LCL and Center line, and the UCL and the center line?