Operation of enlarging the end of the hole to give conical shape at en – McqOptions

MCQOPTIONS

1.	Operation of enlarging the end of the hole to give conical shape at end is known as
A.	Drilling
B.	Reaming
C.	Boring
D.	Counter sinking
Answer» E.

Discussion

No Comment Found

Related MCQs

If 20mm hole is needed to be drilled using a drill having point angle of 15 degrees. Value of compulsory approach in mm is
If 20mm hole is needed to be drilled using a drill having semi point angle of 15 degrees. Value of compulsory approach in mm is
If ‘D’ is hole diameter, then general value for a compulsory approach for blind hole can be taken as
If ‘D’ is hole diameter, then general value for a compulsory approach for through hole can be taken as
IF_20MM_HOLE_IS_NEEDED_TO_BE_DRILLED_USING_A_DRILL_HAVING_SEMI_POINT_ANGLE_OF_15_DEGREES._VALUE_OF_COMPULSORY_APPROACH_IN_MM_IS?$
If_20mm_hole_is_needed_to_be_drilled_using_a_drill_having_point_angle_of_15_degrees._Value_of_compulsory_approach_in_mm_is$
If ‚Äö√Ñ√∂‚àö√ë‚àö‚â§D‚Äö√Ñ√∂‚àö√ë‚àö¬• is hole diameter, then general value for a compulsory approach for through hole can be taken as$
Operation used to form internal threads is known as
Operation of enlarging the end of the hole to give conical shape at end is known as
Process of enlarging only a small part of hole is also known as