MCQOPTIONS
Bookmark
Saved Bookmarks
→
Electronics & Communication Engineering
→
Signals And Systems
→
Midpoint bias for a D-MOSFET is ID = , obtained b...
1.
Midpoint bias for a D-MOSFET is ID = , obtained by setting VGS = 0.
A.
idss / 2
B.
idss / 3.4
C.
idss
Answer» D.
Show Answer
Discussion
No Comment Found
Post Comment
Related MCQs
The Norton current is sometimes called the
Kirchhoff’s current law is applicable only to
How many transistors must be used in a class B power amplifier to obtain the output for the full cycle of the signal?
Which type of amplifier uses pulse (digital) signals in its operation?
In class A operation, the operating point is generally located                of the d.c. load line.
What is the maximum efficiency of a class A circuit with a direct or series-fed load connection?
The Q-point is at cutoff for class operation.
Which type of power amplifier is biased for operation at less than 180º of the cycle?
Heat sinks reduce the
Class-C amplifiers are almost always
Reply to Comment
×
Name
*
Email
*
Comment
*
Submit Reply
Your experience on this site will be improved by allowing cookies. Read
Cookie Policy
Reject
Allow cookies
