MCQOPTIONS
Bookmark
Saved Bookmarks
→
Manufacturing Engineering
→
Gas Welding Gas Cutting
→
Intersection of each faces and flank form
1.
Intersection of each faces and flank form
A.
Body
B.
Point
C.
Lip
D.
Chisel edge
Answer» B. Point
Show Answer
Discussion
No Comment Found
Post Comment
Related MCQs
Narrow flat surface running along flutes of twist drill on its leading edge is known as
Which of the following help in reducing friction between drill and the walls of the hole in twist drills?
Small clearance provided in diameter of twist drills adjacent to land is known as
Intersection of each faces and flank form
Main cutting part of drill is
Cone shaped surface formed at the end of the flutes which contains dead centre, lips and flanks etc. is known as
Edge formed at extreme tip due to the intersection of flanks, is known as
Part of drill between neck and tang is known as
Part of twist drill which carries flutes and extends from dead centre up to the start of the neck is known as
Reply to Comment
×
Name
*
Email
*
Comment
*
Submit Reply
Your experience on this site will be improved by allowing cookies. Read
Cookie Policy
Reject
Allow cookies
