In AutoCAD the Hatch tool is used to designate what pattern is to be u – McqOptions

MCQOPTIONS

1.	In AutoCAD the Hatch tool is used to designate what pattern is to be used for a section view.
A.	1
B.
C.	1
D.
Answer» B.

Discussion

No Comment Found

Related MCQs

The section lines in all hatched areas for an object must be parallel.
It is not acceptable to use the general-purpose symbol at different angles for different parts.
The ANSI 131 hatch pattern is the AutoCAD default hatch pattern.
Section views cannot replace the normal top, front, side, or other standard orthographic views.
A section-lined area is always completely bounded by a visible outline.
One of the outcomes of using section views in a technical drawing is the elimination of hidden lines.
The arrow points on either end of a Cutting Plane line indicate the direction of view.
The visible edges of the object behind the cutting plane are not cross-hatched.
In technical drawing a section view is often used to reveal some or all of an object's internal features.
The angle of revolution should always be less than 45 degrees for an aligned section.