In a shaping operation, the average cutting speed is ( Stroke length – McqOptions

MCQOPTIONS

1.	In a shaping operation, the average cutting speed is ( Stroke length S, Number of strokes per minute N, Quick return ratio R)
A.	NSR
B.	NSR/2
C.	NS(1 + R)
D.	NS(1 + R)/2
Answer» E.

Discussion

No Comment Found

Related MCQs

In a shaping operation, the average cutting speed is ( Stroke length S, Number of strokes per minute N, Quick return ratio R)
Inversion of a kinematic chain relative to some other links is a property of the chain and is not that of the mechanism.
In Oldham’s coupling the condition for maximum speed ratio is
Oldham’s coupling is used to transmit power between two parallel shafts which are slightly offset.
Which of the following are inversions of a double slider crank chain?1. Whitworth return motion 2. Scotch Yoke3. Oldham’s Coupling 4. Rotary engineSelect correct answer using the codes given below:Codes:
INA_KINEMATIC_INVERSION,_THE_RELATIVE_MOTIONS_BETWEEN_LINKS_OF_THE_MECHANISM_CHANGE_AS_DIFFERENT_LINKS_ARE_MADE_THE_FRAME_BY_TURNS.?$
IN_A_SHAPING_OPERATION,_THE_AVERAGE_CUTTING_SPEED_IS_(_STROKE_LENGTH_S,_NUMBER_OF_STROKES_PER_MINUTE_N,_QUICK_RETURN_RATIO_R)?$
An elliptical trammel is a mechanism with three prismatic pairs and one revolute pair.$
Inversion of a kinematic chain relative to some other links is a property of the chain and is not that of the mechanism?
For one degree of freedom planer mechanism having links, which one of the following is the possible combination?