In a radio receiver, AGC works by – McqOptions

MCQOPTIONS

1.	In a radio receiver, AGC works by
A.	Tuning the local oscillator
B.	Turning off the audio section in the absence of a received signal
C.	Adjusting the gain of RF and IF
D.	Limiting the signal level using a clipper in the audio section
Answer» D. Limiting the signal level using a clipper in the audio section

Discussion

No Comment Found

Related MCQs

A radio receiver is tuned to 750 kHz and its oscillator frequency is 925 kHz. The image frequency would be
If a radio receiver amplifies all the signal frequency equally well, it is said to have high
For this RF Circuit, the correct statement is:
A superheterodyne AM broadcast receiver has an IF of 455 kHz. If it is tuned to a frequency of 700 kHz, the image frequency is
Decoding, storage, and interpretation are the process steps of ______
Noise figure for an ideal receiver is ______
In a superheterodyne receiver, if the intermediate frequency is 450 kHz and the signal frequency is 1000 kHz, then the local oscillator frequency and image frequency respectively are
In a typical AM receiver circuit, the oscillator frequency is
In a broadcast superheterodyne receiver, having no RF amplifier, the IF = 455 kHz. What is the image frequency if the receiver is tuned to 1000 kHz?
Calculate the rejection ratio at 1000 kHz for a broadcast superheterodyne receiver having no RF amplifier. The loaded Q of the antenna coupling circuit is 100. Intermediate frequency is 455 kHz.