IN_______________A_HIGH_VOLUME_FLOW_OF_THE_CUTTING_FLUID_IS_GENERALLY_ – McqOptions

MCQOPTIONS

1.	IN_______________A_HIGH_VOLUME_FLOW_OF_THE_CUTTING_FLUID_IS_GENERALLY_APPLIED_ON_THE_BACK_OF_THE_CHIP.?$
A.	flooding
B.	jet application
C.	mist application
D.	all of the mentioned
Answer» B. jet application

Discussion

No Comment Found

Related MCQs

_______________ acts downward on the tool tip.
______________ controls both direction of chip flow and the strength of the tool tip.
In _________ the cutting fluid, which may be either a liquid or a gas is applied in the form of a fine jet under pressure.
In _____________ a high volume flow of the cutting fluid is generally applied on the back of the chip.
The methods of application of cutting fluids are
The cutting fluid mostly used for machining steel is:
IN_______________A_HIGH_VOLUME_FLOW_OF_THE_CUTTING_FLUID_IS_GENERALLY_APPLIED_ON_THE_BACK_OF_THE_CHIP.?$
______________ controls both direction of chip flow and the strength of the tool tip.$
In___________the_cutting_fluid,_which_may_be_either_a_liquid_or_a_gas_is_applied_in_the_form_of_a_fine_jet_under_pressure.$
For turning a small taper on a long workpiece, the suitable method is