In a CAD system, you can draw an ellipse by specifying these: – McqOptions

MCQOPTIONS

1.	In a CAD system, you can draw an ellipse by specifying these:
A.	The bounding lines
B.	The midpoint and end points
C.	The center and major and minor axes
D.	The center and radius
Answer» D. The center and radius

Discussion

No Comment Found

Related MCQs

The figure below represents _____________ point perspective.
This figure below is a _____________ in oblique projection.
A variant of ___________ is called military projection.
In _________a point of the object is represented by three coordinates, x, y and z.
The term __________ stems from its use in illustrations by the furniture industry.
Oblique sections are useful to show the _____________
In oblique projections, one of the object’s principal faces is parallel to the plane of projection.
When the receding lines are true length, and the projectors are at 45 degrees to the plane of projection, the oblique drawing is called ______________
When the receding lines are drawn to half size, the drawing is known as a cabinet projection.
In oblique projections, one of the object's principal faces is parallel to the plane of projection.